White UPVC Plastic Flexi Flexible Angle Trim 25mm x 25mm x 2.5 Metre Length

Great product, ideal for what I needed

Comes rolled up but straightens easily. Used this to add a neat finish to some cladding on porch and it has really tied our project together. Easy to cut and is flexible, bends without worrying it might snap. A great affordable way to achieve a professional finish.

I had redecorated my shower base board and needed and angle trim to replace the one that was broken before.This trim is easy to cut to size with a strong cutting knife, but as it doesn't have any self adhesive to it, i have had to use some silicone that i was already using to finish the shower glasses.In order to bend the trim for the corner that i needed, i have followed the instruction from other reviewers , and have directed a hair-dryer for 10 seconds which made the trim easily foldable into the shape i needed. And job done.I think someone else sells this type of trim with self adhesive elsewhere but i was quite happy with this one as i already had at hand an opened silicone gel.After positioning the trim at the angle i needed, i have sellotaped it to the base until the silicon was dry to keep the trim in place.I am including some pictures to show you the job before and after.I am happy with the result😊 ☺️

Cover corners

Great trim for bathroom decor

Arrived on time. Followed instructions warmed up on radiator gently bent to 90 degs. over edge of desk fixed to wall with double sided tape. Next day it was off the wall that's down to me but the plastic had cracked along the bent line by about 300mm. I have used double sided pads to stick to wall and they are holding ok. When the sun comes out again I will try bending another piece and try again.

No problems

Overall this is a really good product. I installed on a couple of exposed corners in our house that were getting knocked quite badly (with two boys in the house!). Cutting to size was ok - measure and use a sharp small hacksaw. The challenge was carefully bending to the corner - and i did find one end did split down the middle (where the corner was). I did think this would be a major problem - but i used No-nails to install and i could still keep the edge no issues. I might try with the next one i have to install putting the edging in warm water for a few minutes so it is more malleable and less brittle.