Granite & Marble Repair Kit

Despite some reviews of not getting hard or hard to work with I thought I would try this product anyway because I had a feeling, like other epoxy products if you don’t mix exactly, you will have problems. Either too much hardener, its tough to work with, not enough and it doesn’t set! I measured out these products with a 1/4 teaspoon, one scoop of each. It’s important not to eyeball this if your not a professional. It mixed up well and was easy to match my grey counter top color. Before hand I did tape the area off as to not create more sanding then I needed to. It was easy to apply and I got a good 15 minutes of workable product. As for drying, it says 4 hours but you must take into consideration temperature and humidity in your house. After 4 hours mine was set enough to remove the tape and I was able to use a straight edge to remove the little residual spots but it was still soft, just not gooey. I started yesterday at 3:00 pm, removed the tape at 7:00 pm and by morning it was rock hard. If you do this correctly and put the extra time into it it will work like a charm!! Im completely satisfied with this product and the outcome!!

I had a chip in my quartz counter top on the edge of the sink and use the repair epoxy to glue in the chip and fill the edge. Colour match mix was really close and after sanding, it’s hardly noticeable. I’d recommend finishing with 5000 grit wet and dry paper followed by a polish.

For the little chip we had on a quartz bathroom edge, it was more than sufficient compound, one could have filled larger holes too. After 4 hours drying time it was perfect for sanding, blends in with the surface, even shines the same after polishing a bit.

Had a small piece off the edge of our quartz counter broken from being hit by a heavy metal object. Things looked grim. I figured this surely couldn't make it look worse. I was able to slowly get a color match before applying it carefully and pushing/flattening the resin into place. Proper prep work of thoroughly cleaning the area with alcohol is essential to avoid adhesion issues that some of the folks here complain about but didn't realize were self-created issues. Waited 48 hours then sanded it all down beginning with 600 then 1000 grit. The result was astonishing. I've attached a picture which shows what the counter looks like now. Truly, unless you're looking at it with a magnifying glass from 2 inches away, you can't tell anything ever happened. So very pleased. One tip: use masking tape religiously to minimize resin touching any spot unintended. This makes blending much easier. Be patient and careful with the sanding as well. Also underline the statement of a little going A LONG WAY with the color. It's much easier to darken then lighten your color so whatever color you think, start with only a third the amount. For context I used 1mm length of black to get a dark gray with the white resin on a half teaspoons worth of resin.

I am never getting the best results but it does the job. I clean very well but sometimes the filler still comes off.