CHANCS 775 Motor DC 12V/24V Table Saw Kit High Power Torque Circular Saw with Saw Blade Chuck and Saw Blade

* This is a combination of motor, bracket, B10 drill chuck and PWM 20A speed controller, it can be used with saw blade to become a mini saw.

* Engine Specifications:
Rated Voltage: DC 12V, No-load Speed: 10000RPM, Charging Speed: 8800RPM
Rated voltage: DC 24V, No-load speed: 20,000 rpm, charging speed: 17,600 rpm.
Starting current: 4-5A
Motor body diameter: 42 mm.
Motor body length: 66.5 mm.
Bar length: 16 mm.
Bar diameter: 5 mm.

* Stand Features:
Length: 50 mm.
Width: 52 mm.
Height: 53 mm.
ing Hole Diameter: 4mm
Thickness of the bracket: 3 mm.

* Speed Controller Features:
Input Voltage: DC 10V-DC 60V (Ultra Wide Operating Voltage)
Output voltage: Linear under load
Control power: 0.01-1200W
Rated current: 10A
Maximum current: 20A (long-term use of 10A, 450W or less, pay attention to keep the module free from heat dissipation conditions. );
PWM duty cycle: 0% to 100%
PWM Frequency: 25KHz
Product Dimensions (L x W x H): 77 x 45 x 28 mm.

Attention:
1. About PWM, please do not connect AC power directly (such as 110V AC), the input voltage of this controller must be DC 9V-60V, otherwise it will be burned.
2. Make sure the positive and negative connections are correct before turning on the motor speed controller, it will be damaged if the supply voltage is connected with wrong polarity.

Package includes:
1 x DC Motor
1 x PWM Speed Controller
1 x Stand
1 x B10 chuck
2 x Screws
2 x Assorted Hardware Tools

• * This is a DIY combination of motor, bracket, B10 drill chuck，and 20A PWM speed controller, it can be used with a saw blade to become a mini saw..
• The specification of motor: Rated Voltage: DC 12V, Unloaded Speed: 10000RPM, Load Speed: 8800RPM. Rated Voltage: DC 24V, Unloaded Speed: 20000RPM, Load Speed: 17600RPM. Starting current: 4-5A Motor Body Diameter: 42mm, Motor Body Length: 66.5mm, Shaft Length: 16mm, Shaft Diameter: 5mm..
• The specification of bracket: Length: 50mm, Width: 52mm, Height: 53mm, ing hole diameter: 4mm, Thickness of bracket: 3mm..
• The specification of the speed controller: Input Voltage: DC 10V-DC 60V (Ultra wide working voltage); Output voltage: linear under load; Control Power: 0.01-1200W; Rated Current: 10A; Max Current: 20A (Long-term use of 10A, 450W or less, pay attention to keep the module free of heat dissipation conditions.);PWM Duty Cycle: 0%-100%; PWM Frequency: 25Khz;Product Size(L x W x H): 77*45*28mm;.
• Attention: 1.About the PWM, please do not connect AC power directly(Such as:110V AC),the input volt of this controller should be DC 9V-60V,otherwise it will be burned out. 2.Make sure the positive and negative connections are correct before powering on the motor speed controller, it will be damaged if connect the supply voltage with wrong polarity..