Colour Name:Blue

Specifications：

Color:blue/orange（for choice）

Material: Plastic + Metal

Voltage: 10.8V

Battery: Lithium Ion Batteries

Battery Capacity: 1500 mAh

Battery Charging Time: 1.5 hours full filling

Tying Wire Diameter: 0.8mm

Tying Wire Length: more than 110 m

Applicable Scope Of Steel Strapping: 8mm - 34mm

Knot Wire Length: 300 - 500mm

Knot Number Per Charge: 1500 times

Knot The Required Time: 0.8 seconds at a time

Machine Size: 275 mm * 65 mm * 240 mm / 10.83''x2.56''x9.45''(appr.)

Tying Wire Installations：

1. In the state of start-up, press the locking plate of the opening wire plate, open the plate cover.

2. Take out the tying wire, tear the packaging film, pull straight wire head about 10 cm, load into the binding machine in the clockwise direction, the wire head into the guide tap tube.

Note: Clench the wire plate when tear the packaging film, do not let the wire loose. If the wire is free to disperse, it will lead to the spread of the wire stuck in the wire plate.

3. Insert the head of the wire guide into the tap pipe until it is resisted.

4. Cover the plate and fasten the locking piece.

5. Pinch the wire forward with two fingers, press and hold the switch and send the wire out.

6. If you want to take out the wire plate when finished, press and hold the locking piece, open the wire plate cover plate, holding the wire tray to the side and pull out.

Operation Instructions：

1. The rebar tirer's jaws are stuck to the intersection of the steel bars, and the steel bars are hooked at 45 degree angles.

Note: There can be no barrier between the mouth of the jaws and the wire.

2. Press the start switch, the rebar tirer machine carries on the work (spins, hinges tightly, cuts off)

Note: Press one button at a time, do not probe the jaws at work.

3. When automatic