Geekpure 10-Inch Whole House Slim Water Filter Housing for 2.5" x 10" Filter - 3/4"NPT Brass Port - with Air Relief Valve-Blue (1)

The media could not be loaded. I've installed several water filter housings over the years and have never had this issue. The O ring does not make a good seal. It doesn't matter how tight I make it. Now I have to replace the housing which is extremely inconvenient.Edit: the company reached out and offered a full refund. Bumped up from 1 star to 3 starsEdit 2: the company is sending me a replacement oring. Up to 5 stars for good service and addressing the issue

I already have the 5” x 10” Geekpure whole house water filter housings and they work great. Easy to change out and no problems.Therefore I went with this 2.5” x10” housing for hooking up with my water dispenser unit next to the kitchen sink. This is a “ freebie “ from the builder but it requires proprietary filters that are very expensive. Instead I used the same 1/4” lines to hook up this unit. I used Sharkbite 1/4” to 1/4” couplings to lengthen the supply and feed lines so that instead of having the unit way in back and difficult to change the filters, I have it moveable so it is easily accessible for changing the filters or O ring if needed. This way I place the unit in a smaller bucket so any water that spills isn’t a problem. This also means I did not use the mounting bracket for the unit either but could have. If you just mount it so that you can slide it off easily than there is no stress on the bracket when torquing the body to loosen or tighten the body when changing the filter.Just be careful because most sink cabinets do not have very thick walls and if you use an anchor you might go through to either the dishwasher or into an adjoining cabinet. Another reason I find not mounting it works well.I have posted a question to Geekpure asking which manufacturer is best for replacement O rings for their product. Might help someone else out too.I always use Vaseline on O rings.

ok

Unfortunately, another example of poor quality Chinese crap. Housing uses brass threaded inserted but the bond between the insert and housing leaks on both inlet and outlet similar to what was described in other reviews. I installed it twice to verify that the theads sealed - they did. the leak was due to poor manufacturing quality control. It also comes with a very flimsy plastic mounting bracket the is unsuitable for any installation where unit isn't supported by the pipes (ie, flexible lines like PEX). Thankfully Amazon's return policy let me send this back.

This whole house filter is excellent, very well made. I use it to filter my waste motor oil and it has held up very well.

Hard to stop from leaking

Everything it’s to be

Added this filter housing to my fish room filter setup to use with a phosphate removal cartridge. Works great, does not leak.