Microphone Stand, URMI Heavy Duty Table Microphone Arm Stand with Dual Layered Mic Pop Filter Suspension Boom Scissor Arm Stands for Recordings Broadcasting Streaming Singing for Blue Yeti Snowball

The Adjustable Microphone Boom Arm Stand is a game-changer. It's flexible, sturdy, and gives my setup a professional touch. Easy to adjust and stays in place. Five stars for upgrading my mic game!

I recently bought a blue snowball mic and wanted this stand so I could have the mic closer to my face when talking. The stand is a lot smaller than I expected it to be but is easy to set up and is good value considering it only cost £12.99. Once attached to my desk, the stand feels pretty sturdy but for some reason, if I've moved the stand arm a few times, some of the nuts become a but loose. It's not a massive deal considering it's a budget stand but can be quite annoying even if it is an easy fix.

A quality piece of kit, especially if you are just starting out YouTubing etc.The table clamp that comes with the stand is pretty sturdy and well made and has a maximum table width of about 2.1 inches or 55mm, so if you have a bigger table than that you may have to improvise a little bit.The pop filter that comes with the kit is very good also and it's quite rigid to allow for it to stay in position, but also allowing you to manipulate it how you like at the same time. A good pop filter alone is worth around 5-7 pounds, so to get this with a quality mic stand is a bargain!The mic stand itself, like the pop filter is rigid but also flexible enough to move into position. The stand can also rotate and go up and down to fit your needs too. My first impressions of this product is that it's definitely worth a buy, especially for the price it's currently sitting at! Just bare in mind when you purchase it the max weight it can support is only 4.4 pounds and also it's only really compatible with mics that fit the supplied attachment or mics with a mountable bottom.

A reasonably sturdy, easy to use mic stand. I use it with an SM58 dynamic mic, which is no lightweight, and it doesn't droop in use. I use it for voiceovers for YT videos and for recording audiobooks and it is perfectly adequate. My only concern is that the balancing springs ring for a long time if you tap it or the desk, which you shouldn't be doing anyway

quite flimsy and didn’t lock in place well!

I was looking for a microphone and stand which could be clamped to a desk or table. This cantilever stand is extremely sturdy in construction and moves very smoothly into the required position.It clamped firmly to my table (see photo) and has rubber top and bottom of the clamp to protect the surface. The spigot at the top should fit most micrphone cages and holders, there is also an adapter included for this purpose. A foam microphone cover is included to reduce noise as is a really nice flexible pop filter which swings round in front of the microphone to reduce or eliminate popping sounds caused by the mechanical impact of fast-moving air on the microphone during recorded speech and singing.This is a very well made stand and would not look out of place in a recording studio.

writing this review primarily because I spent 2 hours searching for a mic stand that could hold the weight of a rode NT1-A which wasn't £70+!if you're on a budget this will work with a fair bit of tweaking but it works nonetheless. definitely not perfect but at this price I cannot complain!value for money is good it feels very sturdy when balanced in the right place and although it doesn't hold the mic at every angle you can find the angle which works best and holds, for me that's slightly twisted towards the right!was very easy to set up also and I think the build quality is good however I will see how it holds out over the coming months!

This mic stand has an adjustable screwing fitting for both my office desk and dining table, and the arm is able to be manipulated to reach any position i need and stay where i put it. My pop shield clips on easily and this has made my podcasting much easier and noise free.

Dieser Microfon Ständer ist Spitze muss nur noch das passende Micro kaufen.

Ottimo per trasmettere in streaming

Commande reçue en avance, montage facile!

Ist ein guter Mikrofonarm welcher zum zocken ausreicht. Bei mir hängt das Auna Mic 900B dran ohne Probleme. Er muss nur gut eingestellt werden, ist aber sicher nicht mit Markenmodellen gleichzusetzen.

Ich habe es zum glück drauf bekommen...es war sehr knapp aber es hat gepasst...Ich bin froh und es klapp alles wunderbar...Bis jetzt nichts zu mekern...